Injection molding DFM

Injection molding DFM, judged against your resin.

Upload a STEP file of a plastic part and Protyus works out how the mold opens, where it splits and what each undercut needs. It maps the wall thickness, judges draft, ribs and bosses against the resin you choose, and gives the cavities, the shot cycle and a cost per part.

The mold

How it opens, and what it needs to release the part.

Pull direction and parting line
Which way the mold opens and where it splits, shown through the part, with the core and cavity sides colored.
Undercuts
Each undercut as a slide, a lifter or a bump that strips off the core, with the travel it needs.
Gates and flow
Estimated gates, the flow ratio and where weld lines form.
Cavities
How many cavities fit the press, and what stops the next one.
The part

Walls, draft, ribs and bosses, held to the resin.

Each check is judged against the resin you choose, and the part gets a score in it.

Wall thickness
A thickness map of the whole part, with a slider to show only the walls between two thicknesses.
Draft
Draft on the faces that have to release from the mold.
Even walls
Where the wall gets thicker or thinner than the resin likes.
Ribs and bosses
Each rib and boss checked against the resin, and picked out on the part where it falls short.
Undercuts
The undercuts that add a slide or a lifter to the mold, and those that don't.
Compare materials
The same part scored in every resin, side by side.
Time and cost

Cavities, cycle and cost per part.

Shot cycle
The cycle by phase, and seconds a part.
Cost per part
A cost per part at your annual volume, with the press hours a year it takes.
By cavity count
The cost at each cavity count, with a rough cost for the mold, and the count that makes a part cheapest with its mold.
Read next

DFM analysis

How findings are ranked, and how a DFM check leads to a cycle time and a cost.

CNC machining DFM

What a machinist would push back on, with the setups on 3-axis to 5-axis machines.

Sheet metal DFM

The flat pattern, bend checks and cost per part for parts cut and bent from sheet.

AI DFM

Ask Protyus AI about a part, or connect your own agent.

Questions

What people ask.

Anything else? Email us.

What does an injection molding DFM check look for?

Wall thickness, draft, even walls, ribs, bosses and undercuts, judged against the resin you choose, with the parting line and the slides or lifters the mold needs. A molded part gets a score rather than a pass or a fail, and each finding says why it matters and the change that fixes it.

Does my part need slides or lifters?

Protyus works out the pull direction and the parting line, then names each undercut as a slide, a lifter or a bump that strips off the core, with the travel it needs. A part with none says so.

How many cavities should the mold have?

Protyus gives how many cavities fit the press and what stops the next one, then the cost per part at each cavity count with a rough mold cost, so you can see the count that makes a part cheapest with its mold.

Can I compare resins?

Yes. Compare materials scores the same part in every resin, so you can see which it suits.

Does Protyus run a mold flow simulation?

No. The gates, the flow and the weld lines are estimates from the part's shape, for early design decisions, and they're labeled as estimates. They don't replace a flow simulation before the mold is cut.

Is injection moulding the same as injection molding?

Yes. Moulding is the British spelling and molding the American one, for the same process. Protyus checks the same things whichever you search for.

See how your part will be molded.

Protyus is opening to shops, suppliers and design teams by invitation. Ask for early access, or write to us with any question.